Slicer Discord
Pill Packer 100x – 3D printable model from Thingiverse Thingiverse

Pill Packer 100x

by adolist
320 Downloads
252 Likes
0 Makes
Go to Model
Introducing the Pill Packer 100x! Fill 100 "00" (750mg) and/or "0" (500mg) vegetable capsules at a time using whatever powder supplement you desire.

There are only three functioning parts: the pill holder, packer, and platform

Place the holder on top of the platform making sure is slides onto the cylinder and latches onto the notch. Then place a rubber band over the end of the notched side, if you plan on moving it around or packing them fairly hard. Place the capsules open end opposite the platform into the desired amount of slots then poor your powdered material over the capsules. Take a postcard, credit card or simply a piece of paper and wipe the excess off the top making sure to fill each hole as you move the card around. Take your packer line it up with each pill and press down firmly until the packer starts to sink down into the holes, pack to desired depth using small taps of the hand to press the powder down firmly.

Taking the pills out is simple, remove the rubber b
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection