MakerWorld
Decor
Vai al Modello
Pin Back Magnetic Converter
35
Download
14
Likes
25
Makes
Looking for a way to finally display all the enamel pins you've been collecting over the years?These fully re-usable pin backs convert your pins into magnets to spice up your fridge, metal doors, or any other magnetic surface! They take under 15 minutes to print and use less than half a gram of filament each. A batch of 50 pin backs only takes about one hour. This model uses a 2x8mm magnet. I have not had to glue any of my magnets, just pushing into place as far as it will go. A drop of glue would not hurt at all, especially if you plan on moving them around a lot. I find this size of magnet to be a good compromise between strength and size. The design features a sleek profile that really allows your pin to shine. Take care to not break the prong while pressing the pin into the pin back, as there may be a bit of resistance during the first use. The pin back grips the pin securely in place but may loosen over time. Thank you very much for downloading! Feel free to reach out if there
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!