Pin Board Pegs

These are pegs to be used for any of my pinboard models. With these, my pinboards can be used to hold almost any trinket These pegs just slot into the holes on every pinboard on my page, they are a tight press fit so they may require some force to go in. There are 3 different types of pegs: Hanger (Silver in photo) - Used to hang keychains, etc. from the pinboard Tack (Grey in photo) - Used to tack on photos or thin prints (eg., Hueforges) - These are difficult to remove once placed, they may need to be pried off with something flat for leverage. Shelf (Green in photo) - Used to support thicker objects from below Depending on the tolerances of your printer they may need to be scaled up or down 1% to be a tight fit. You can also glue them from the back if you don't plan on moving them around.