Pinch Camera Mounts

A set of heavy duty camera mounts for the Tinywhoop FX965TW Pinch camera/vtx. One is a 'normal' height mount, the other is a low profile mount. Both have 20 degrees of up tilt and do a good job of locking that tiny camera in position. If you use the listed filament type and print settings, this mount will weigh as much as three times Tinywhoop's own mount once you add the double sided tape to stick the vtx in place. I also recommend a bit of double sided tape on the bottom of the low profile mount too; a hard enough impact can still push the camera board below the mount and onto your flight controller even with that lower brace. The normal height mount will fit the legacy Tinywhoop Razor and Stingray canopies in addition to my own Swoop and Sloop canopies. (Sorry, I don't have the newer versions of Tinywhoop's canopies to test the fit.) The low profile version fits my Stoop, Swoop, and Sloop canopies, though it was really optimized for the Stoop.