Pine A64 Two-Parts case

**WARNING**
Cases with fan support have been removed, the position was wrong and didn't match the CPU.
I will add them again later.



So this is basically the Pine Brick Case without the sliding element. Easier to print, easy to mount.

Parts needed to close the case:
- 4xM3 screws, 29mm long
- 4xM3 nuts

Print with supports **touching buildplate**.

Files description:
- bottom.stl: The bottom of the case
- top.stl: The top of the case, with no additional holes (as shown in the pictures)
- top_buttons.stl: The top of the case, with holes for power/reset buttons
- top_GPIO_EULER.stl: The top of the case, with holes for GPIO and EULER bus
- top_buttons_GPIO_EULER.stl: The top of the case, with holes for power/reset buttons, GPIO and EULER bus
- top_30x30fan.stl: The top of the case, with holes for a 30x30mm fan.
- top_30x30fan_buttons.stl: The top of the case, with holes for a 30x30mm fan and power/reset buttons.
- top_30x30fan_buttons_GPIO_EUL