Thingiverse
Electronics
Model downloaden
Pinecil - T12 Tip Adapter
86
Downloads
61
Likes
0
Makes
Adapter to seat T12 soldering iron tips into the Pinecil.
Depending on the brand of your T12 tip and how hot you run your iron, you should consider using a high temperature filament.
I ran my Pinecil at 320 Celsius for a hour using a Quicko brand tip. -
The 20mm tip area above the adapter did not give off any significant heat (touchable). So whilst I was able to use PLA - I would highly recommend yourselves using a high temperature resistant filament.
Depending on the brand of your T12 tip and how hot you run your iron, you should consider using a high temperature filament.
I ran my Pinecil at 320 Celsius for a hour using a Quicko brand tip. -
The 20mm tip area above the adapter did not give off any significant heat (touchable). So whilst I was able to use PLA - I would highly recommend yourselves using a high temperature resistant filament.
kohkoh publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
