Pinecil v2 case with strong lid

A case for your Pinecil v2 with a strong, securely latching lidDesigned to be printable with fat (0.8mm) nozzlesDemo: https://www.youtube.com/shorts/EIUq69howeI Notes: Print the lid with a long thin edge on your print bed Print collar and body in vertical orientation (as-is from design files) I created this in Tinkercad and made a copy public here:https://www.tinkercad.com/things/ixnVEXfQAi8-copy-of-pinecilv2-case/edit?sharecode=Lpg2z-3yCUEy58Q-9bRZjc3rv2BUtLpwAM_45SfKI_EPost-PrintingPost ProcessingLightly sand the edges of the lid if and as needed.Assembly PrepCut two short lengths of filament approximately 30mm each.Cut a small piece of foam (e.g. from Pinecil retail packaging) approximately 2x10x10 mm.Super glueWire cutters (to trim filament)Sandpaper (fine grit)A pencil or other low-cost item capable of reach the bottom of the Pinecil slot in the caseDry FitSlide collar over body and align holes with the notches in the bodySlide a length of filament through the holes to secure the