Thingiverse
Pinned Hinge
von Littlenuts
2
Downloads
5
Likes
0
Makes
Plenty of RC hinges on here but most were not symmetrical so I though I would print one modeled after a popular brand.
This is best printed standing on it's edge, and with supports. Takes a piece of 0.7-0.8mm piece of piano wire as the hinge pin (or a cut off T pin). Worked well. Only post processing was to clean the holes with a 1mm drill. It is symmetric so just print two and assemble.
This is best printed standing on it's edge, and with supports. Takes a piece of 0.7-0.8mm piece of piano wire as the hinge pin (or a cut off T pin). Worked well. Only post processing was to clean the holes with a 1mm drill. It is symmetric so just print two and assemble.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
