PinSim Cabinet

This is a Cabinet I designed for the Open Source Project: PinSim
https://github.com/Jerware/PinSim

Printed with a CR10 S5 - large format printer. However I was still not able to print it as a solid piece. I used a few different bolts, Mostly M4s. If there is significant interest in this project I will create a better manifest. All of the electronics I used can be found in the PinSim Github page listed above.

I designed the print in place hinges myself, as well as all of the test features to make sure the buttons and such fit properly before printing the whole thing.

I noticed on the version I printed out that some of the screw holes were a bit too large, so I reduced them, and have not tested the new size. I also noticed there was a bit too much play in the finger joints holding them all together, and you may want to reduce that tolerance a smidge.

I have included the .F3D file so you can make alterations if you like. As well as the test fixtures.

This project is not f