Thingiverse
PIP Cable Management Clip
von whosbuzzin
132
Downloads
68
Likes
0
Makes
I printed .15 layer height
The hinge clearance is .3mm
Print on its side so the hinge is vertical. I added supports just for the part where the hinge is, it snaps free easily, you may not need them.
The hinge clearance is .3mm
Print on its side so the hinge is vertical. I added supports just for the part where the hinge is, it snaps free easily, you may not need them.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
