Pipboy Display Stand

Disclaimer This is for my models and is not tested with other models. I made this to fit both of my current uploaded models as well as the upcoming raspberry pi pipboy. It uses TPU for the feet but you could use other plastic if you don't want them to be soft. Non-Printed PartsM3x5 Screws - QTY 127mm Washers - QTY 81mm Craft FoamMine has a fair amount of post process done to it. Here are the steps:Dry sand 200 gritDry sand 400 gritWet sand 400 gritBlack uv resin coat. (Foam brush black uv resin from resin printers. Lightly layer and cure until happy with build up)Wet sand 1000 grit1 coat clear matte finish.