Thingiverse
Pipe Clamp 110mm
door Bede98
1
Downloads
1
Likes
0
Makes
This is a Pipe Clamp for 110mm Water Pipe.
I made this because i needed a clamp for pipes under water and stainless ones were not available.
I used 8mm threaded rod with four nuts. One on the inside in the hexagon hole and one with a washer on the outside at the top.Two nuts and washers with about 50mm of the threaded rod were used on the side to clamp the whole thing on a pipe.
I made this because i needed a clamp for pipes under water and stainless ones were not available.
I used 8mm threaded rod with four nuts. One on the inside in the hexagon hole and one with a washer on the outside at the top.Two nuts and washers with about 50mm of the threaded rod were used on the side to clamp the whole thing on a pipe.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
