Thingiverse
Hobby
Zum Modell
Pipe Cleaner Ashtray
697
Downloads
480
Likes
1
Makes
My sister had a commercial version on this ashtray/debowler, but she broke the spike in the middle so I made her a replacement. The original didn't have the cutouts for holding cigars/cigarettes/etc but I thought it was worth adding. The original also melted when she let some flowers burn in it about the same as mine burned when I didn't fully put out a tobacco cigarette in my PLA test print.
The one in the photo is ABS. I decided that a bit more noticeable stink factor, and higher melting/burning point, were worth more than my, or her apartment down. We both make candy so burning PLA/corn syrup/sugar are pretty normal for us.
If you choose to print this, use an appropriate material, and make sure you are able extinguish it quickly. I take no responsibility for your moment of dumb which causes a fire in this ashtray. That's all on you, farkin burnout.
The one in the photo is ABS. I decided that a bit more noticeable stink factor, and higher melting/burning point, were worth more than my, or her apartment down. We both make candy so burning PLA/corn syrup/sugar are pretty normal for us.
If you choose to print this, use an appropriate material, and make sure you are able extinguish it quickly. I take no responsibility for your moment of dumb which causes a fire in this ashtray. That's all on you, farkin burnout.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
