Thingiverse
Pipe handle
von FrankHar
1
Downloads
0
Likes
0
Makes
This handle is made to hold a pipe in between two of the printed models.
You should print at quite high infill (35-50%) to ensure the strength of the parts.
You may need supports for the holes in the model.
The main hole has a diameter of 24mm.
You should print at quite high infill (35-50%) to ensure the strength of the parts.
You may need supports for the holes in the model.
The main hole has a diameter of 24mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!