Pipe On Wall - quick attachment - non permanent

Update 1
Added 3 deg. and 5 deg. tilted up variants,
useful for single side to compensate the PVC curvature over time, under load.

A quick way to attach a PVC pipe on a furniture wall (16 mm thick) or on any other wall of that thickness.
Some wardrobes have the walls going up over the top few extra cm.
That is the main intent, you can quick clamp a pipe with this to put some tie, dress or any other clothes, non permanently.

The pipe is not included in model.
Fits PVC pipes 32 mm in diam, the paint on them can be easily washed with rubbing alcohol.
If is attached only on single side, on a single wall, please keep the pipe shorter than 30 cm.

This is not meant to hang heavy stuff on, however.

If there is elephant foot after print, or you use brim, you may need to clean it before putting on furniture to avoid unwanted scratch.
If there are problems with overhangs, you might need supports, I printed without.

For pipe to fit perfectly you may need some tape, or