Thingiverse
Pipettor Connecting Nut
door MortalTombat
3
Downloads
0
Likes
0
Makes
I found an old file while sorting through my library.
A researcher asked me if I could fix his pipettor. The only thing wrong with it was a cracked connecting nut. This was a quick fix to avoid the down-time associated with waiting for "official" parts to arrive.
The tolerances are a bit relaxed. This could be due to the overhang printing without support. Example: I printed two just pieces (sequentially). One of them fit perfectly, the other did not catch the pipettor barrel as it should have.
The part should probably be printed slowly (30-40mm/s) and at 0.1mm or better resolution.
Update 2/9/17: New design STL added. This one fits the older model Gilson units much better.
NOTE: the design should be printed with the threaded section on top for best results.
A researcher asked me if I could fix his pipettor. The only thing wrong with it was a cracked connecting nut. This was a quick fix to avoid the down-time associated with waiting for "official" parts to arrive.
The tolerances are a bit relaxed. This could be due to the overhang printing without support. Example: I printed two just pieces (sequentially). One of them fit perfectly, the other did not catch the pipettor barrel as it should have.
The part should probably be printed slowly (30-40mm/s) and at 0.1mm or better resolution.
Update 2/9/17: New design STL added. This one fits the older model Gilson units much better.
NOTE: the design should be printed with the threaded section on top for best results.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!