Piplup

Check out my other Pokemon prints →here← and on my Patreon. Project: PiplupPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Base Thickness of 0.64mmThe Max allowed Thickness is 2.4mm and the Actual Thickness is 2.32mm This print uses 6 unique filamentsPLA BambuLab Basic BlackPLA Bambu Basic Green PLA Bambu Matte Marine BluePLA Bambu Matte Ivory White PLA Bambu Basic OrangePLA Bambu Matte Lemon Swap Instructions:Start with BlackAt 0.8mm swap to GreenAt 0.88mm swap to Marine BlueAt 0.96mm swap to GreenAt 1.04mm swap to Ivory WhiteAt 1.28mm swap to GreenAt 1.52mm swap to OrangeAt 2mm swap to LemonAt 2.16mm swap to Ivory White for the rest.