Thingiverse
PIR sensor cover with clamp
von silvermirai
0
Downloads
0
Likes
0
Makes
Cover: https://www.thingiverse.com/thing:291270
Clamp: https://www.thingiverse.com/thing:2373981
Fused the clamp and PIR cover together, removed the screw brackets and added two little groves and a bottom cover with little feet for a snug fit.
If the tolerances are right, the bottom cover will snap in and be held in place.
I printed it on the side with supports to ensure the clamp is strong and it doesn't fuses, the result was great, used PETG with 0.1 mm layer height just to be sure the clamp won't fuse..
Clamped it to a LED mirror arduino project. Mirror's LED strip turns on when the PIR sensor detects someone.
Clamp: https://www.thingiverse.com/thing:2373981
Fused the clamp and PIR cover together, removed the screw brackets and added two little groves and a bottom cover with little feet for a snug fit.
If the tolerances are right, the bottom cover will snap in and be held in place.
I printed it on the side with supports to ensure the clamp is strong and it doesn't fuses, the result was great, used PETG with 0.1 mm layer height just to be sure the clamp won't fuse..
Clamped it to a LED mirror arduino project. Mirror's LED strip turns on when the PIR sensor detects someone.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
