Pistol Holder / Storage

This project start for me to upgrade the cheap side panels that came with this Amazon pistol holder and then I decided to recreate all parts so I could extend as much as I need to in the future. Assembly: Assembly from one side panel using the Cap bolt to threaded rod and slide on side panel, holder, divider, holder, and repeat to desired size using spacers for 6mm rod to close gap when not using Connector nuts. Holder Sizes: 30mm fits most smaller single stack pistols such as Kel-Tec PR-57 and Glock 48 36mm fits double stack pistols such as Glock 19/23 and Springfield XD/Echelon 44mm fits larger pistols such as 2011's or pistols with large magwells Print Settings used: I used PETG, with 2 walls/15% infill for the side panel, 2 walls/8% infill for the middle divider panels and the holders. At the rod holds for the side panel I have modifiers set for 4 walls/20% infill and the holders I have modifiers set for 4 walls/15% infill Parts List: M6 Threaded rod - Amazon Link M6 Hex Drive Sock