Thingiverse
Pistol Mounts for SecureIt panel system
von Riggindncr
52
Downloads
41
Likes
0
Makes
Didn't care much for the pistol brackets that were offered from SecureIt so I designed a few that worked for my application. I printed with 30% infill using PLA and they seem plenty strong for my use.
For the pin mount on, I used pieces of 3/16" brass rod, bent to your preferred angle, then coated with a piece of shrink tube for good measure.
4.21.21
Continued expanding the pieces adding mag mounts and combined mag/pistol mounts.
Glock mag mounts are slightly larger than the standard versions.
Pin mount (EXT) has extended pin locations so you can turn the pistol parallel to the panels.
For the pin mount on, I used pieces of 3/16" brass rod, bent to your preferred angle, then coated with a piece of shrink tube for good measure.
4.21.21
Continued expanding the pieces adding mag mounts and combined mag/pistol mounts.
Glock mag mounts are slightly larger than the standard versions.
Pin mount (EXT) has extended pin locations so you can turn the pistol parallel to the panels.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
