Thingiverse
Piston Keychain
by TheBigHotDog
19
Downloads
19
Likes
0
Makes
This is cool keychain for all the motor enthusiasts out there.
PRINT SETTINGS:
All parts can be printed with out supports. I recommend printing the conrods with 0.12 layer height.
ASSEMBLY:
Join the two parts of the connecting rod and thread a piece of filament through the holes. Then, apply some glue at the joint to secure it completely. Once that's done, align the connecting rod with the holes in the piston and insert the pin. It may take some effort to fit it in as it is designed to be a tight fit, but a couple of taps should make it fit snugly. (I recommend adding a bit of glue to the ends of the pin to ensure it won't come loose).
PRINT SETTINGS:
All parts can be printed with out supports. I recommend printing the conrods with 0.12 layer height.
ASSEMBLY:
Join the two parts of the connecting rod and thread a piece of filament through the holes. Then, apply some glue at the joint to secure it completely. Once that's done, align the connecting rod with the holes in the piston and insert the pin. It may take some effort to fit it in as it is designed to be a tight fit, but a couple of taps should make it fit snugly. (I recommend adding a bit of glue to the ends of the pin to ensure it won't come loose).
TheBigHotDog also publishes on
7 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
