Piston Trophy (real size/full printed)

If you want a commercial license, join my Commercial license club.MembershipIf you want a commercial license, join my Commercial license club. This is full verison of the pistion trophy design. Full size , Bore dia 98mm. There are major feature changes from the semi-assembled one. The piston rod position have 15 degree to 30 degree max angle adjustbility from vertical center line. Pistion have 60degrees adjustbility from horizontal surface. All the connection part will have tight fit by design so you could keep it in position after adjustment.The dripping overhang issue is also taken consider during design process, by the orientation that I put on print file, these amount of overhang will work as friction component to keep the over all fitting tolerancing. At the same time those ugly overhang is not visiable to you after assembled. So, good deal. To proof there is attention to detail on my work, lol. (If your filament have huge sinkage rate, it might cause issue.)There is no other hard