Pitlab GPS Case

I made this case to fit a Pitlab GPS module so that you can glue the case into your plane and easily attach the GPS module. This will add some crash protection too!

There are 3 versions: Open top (V1) fully enclosed top (V2) and Bottom side wire connector (V3), (The bases are not interchangeable and must also be printed for the version you choose)

NOTE: V1 was also updated to add countersinks to the 4 screw holes rather than counterbores, so if you downloaded this before 9/18/2017 10:55pm cst you may want to grab the top plate for V1 again.
V3 was added 1/18/2018 and requires you to desolder the angled header pins from the GPS sensor and resolder in new straight pins to the bottom side of the sensor.