MakerWorld
Vehicles
Go to Model
Pivot Cycles Hitch Cover
10
Downloads
3
Likes
8
Makes
I utilized the blank hitch cover published by grizzie17 and added the Cannondale logo. This hitch will fit a 2" x 2" receiver and will need a bolt to hold it into place. grizzie17 has designed one that works pretty well, though it rattles a bit since it's not a perfectly snug fit. That model can be found at the following link: https://makerworld.com/en/models/212385#profileId-910085 It is recommended to add a brim of no less than 5mm inside and outside when printing this.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
