Pivoting Oiler for Ender 5

This is a pivoting Oiler for the Ender 5. Primary features are:

1.Dual pivoting bracket to allow Oiler to move with filament when spooling.

2.Screw on top cap to retain filament and sponge.

3.Simple fix to 40 x 20 extrusion.

Installation Notes:

1.You will need the following:

2 x M3 Nyloc Nuts
2x M3 x 12 mm Hex Bolts (10mm will work but better with 12mm long bolts).
2 M3 x 1.5 mm Washers
2 x M4 x 10 mm Hex Bolts
2 x 10 x 5 M4 T-Nuts - these are the type of T Nut which can be inserted within the slot and rotated rather than inserting from the end of the extrusion. If you do not have any of these spare I have also uploaded a plastic version of the T-Nut which will be sufficiently strong for this purpose only. I have used the uploaded plastic version on my prototype. You will need to thread the plastic T-Nuts with a M4 Bolt prior to assembly.

2.Make sure the M3 pivot bolts are left fairly loose so to allow the oiler to move easily when the spool is moving.

3.Ca