Thingiverse
Pixel 2 Case tweaked
von betamax
19
Downloads
12
Likes
0
Makes
I've tweaked this pixel 2 case to fix some issues I encountered over months of use.
1. Reinforced the weakest spot, between the power & volume buttons. This spot eventually snapped in every copy of the original that I used.
1. Eliminated a bridge near the camera hole on the 2nd layer.
1. Moved a microphone hole 1mm to get it more centered.
I recommend using Prusa Slicer's support enforcers to place support only in the 3 cutouts (volume, power, usb).
I would print the 1st layer very hot, to get a smooth surface finish.
I use PETG, although any material should work with varying strength.
1. Reinforced the weakest spot, between the power & volume buttons. This spot eventually snapped in every copy of the original that I used.
1. Eliminated a bridge near the camera hole on the 2nd layer.
1. Moved a microphone hole 1mm to get it more centered.
I recommend using Prusa Slicer's support enforcers to place support only in the 3 cutouts (volume, power, usb).
I would print the 1st layer very hot, to get a smooth surface finish.
I use PETG, although any material should work with varying strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
