Pixel Star w/ Mount

This pixel bullet star has 12mm holes and will take a 150 pixels. It's made to print on a bed that has capacity of 200mm. Entire snowflake assembled will be about 19.5" in size. Assembly requires 20 M3 x 6mm screws and nuts. This can be glued in addition to the screws for extra strength.

Currently I have only designed 1 Mount which is for a 3/4" EMT conduit. I added 2 holes to this mount so that you can secure it with screws. The mount itself attaches to the start with M4 x 20mm screws and nuts.

You will need to print 5 of the points and 1 hub.

Update: Included a new mount for a 1.25" EMT Conduit. In order to make this work, you will have to use 2 3/8in-16 x 3-1/2in hex bolt (I used Stainless). They go through the back of the Star Mount piece, through the pipe and get capped off by the Mount Backing. For easy of assembly, I used 2 wing nuts and washers to tie down the mount backing.