Pixel Watch 2/3 Charging Stand

A charging stand for a Pixel Watch 2 or 3 I made in Fusion to learn about 3D modeling. The charger for both watches is identical, including the 45mm Watch 3 (what I have). The base has room to hold the excess cable to keep things tidy on my desk, but if you don't need that you can likely make it thinner and might not need the bottom cap. All the pieces are designed for a tight press fit, with no glueing necessary, but that depends on your printer and it's tolerances. On my P1S, the only changes made from the stock .02mm Standard profile was turning on supports (build plate only, 10 degree threshhold) and it was printed using Elegoo Black PLA (Bulk from Amazon). There is also included, in the .f3d file, a mockup of the Pixel Watch 2 & 3 charging puck that I used to carve out the pieces that enclose it. I've found it allows for a very nice press fit of the charger with all my test prints.