Pizza Fidget spinner

PLA with PETG Support Interface. I used brims This is a fidget spinner in the shape of a pizza pie. Notes on Printing. There is a brim on the bottom to keep the bearings in place during printing. After the model has cooled to lie 25c, heat the bed up to 80c and leave it on for a couple of minutes to loosen the brim to release it easier. Also I used PETG as the interface layer for supports. It comes off clean but it can be a little tricky to get it to release as there is no space between it and the model. I used a torch for a half a second to heat it up to get a side to separate and it came off as one large disc. Have fun.