Thingiverse
PL-259 Cover
by JetFixxxer
1
Downloads
1
Likes
0
Makes
I made this for my antenna feed line. The file is named SO239, but it's for PL-259
Use a couple of tie wraps (zipties), you can also use some silicon to glue the shells together. I also wrapped it with self fusion tape or marine shrink tube which can be found Amazon.
ID is a little big if you want to use self fusion tape on the connector before you put the cover/protector on.
You can adjust the height in the slicer. Make sure you un-tick uniform scale.
I used PETG.
Use a couple of tie wraps (zipties), you can also use some silicon to glue the shells together. I also wrapped it with self fusion tape or marine shrink tube which can be found Amazon.
ID is a little big if you want to use self fusion tape on the connector before you put the cover/protector on.
You can adjust the height in the slicer. Make sure you un-tick uniform scale.
I used PETG.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
