Thingiverse
PLA bushing 8mm better printability
door pavolNovak
633
Downloads
405
Likes
3
Makes
I slightly modified the bearing, I made a little chamfer on the bottom and on the top to make it much easier to use it straight away rather then remove the edge on the bottom. I didnt want to have the chamfer too big becasue I want to use it in Prusa i3 frame where they just sit in rectangular holes and they need edge so they can sit good enough in the position
UPDATE AFTER 2 YEARS! Bushings still fine. ABS, PLA . still the same. Quiet as much as possible and much better printing results than linear bearings.
UPDATE AFTER 2 YEARS! Bushings still fine. ABS, PLA . still the same. Quiet as much as possible and much better printing results than linear bearings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
