PLA-Compatible Dropper, Vase Mode

This is a remixed print in place dropper that is sliceable in cura and probably any modern slicer that has a vase mode.

This is meant to be sliced in *spiralize outer contour* or *vase mode* with 1 wall thickness.

The original walls did not work for me so I edited so that it should work in slicers outside of S3D. It should look completely solid, it is designed so that you use vase mode.

It can be printed in PLA. If your print isn't watertight up the flow. I increased my flow to 107%. The original author suggested you lower extrusion width to 0.34mm and then increased flow to 110% to get back 0.4mm width with a water-tight seal.