PLA Zip Tie (reusable)

I was looking for a solution to pack my chargers neatly without the cables getting always entangled and I didn't have reusable zip ties around, nor any flexible filament, so I came up with this.

Features:
- 2 layers thick*
- 5 minute print (+/-5minutes)
- Scalable
- Reusable
- Chainable

*In order to make it strong and flexible enough, you really need to make sure the print doesn't have any holes or gaps between lines and that the layers weld strongly enough together. If you have trouble with this, then try increasing the filament flow percentage.


NEW Zip Tie V2!
- 2x Longer
- Has couple of holes for mounting it or hanging it somewhere when and if needed.
- Improved holes area; widen a bit to make it stronger.

I haven't tested it due my printer being out of order atm, so please try it and report the results thank you very much!