Thingiverse
Plamp v2
by mj1993
5
Downloads
5
Likes
0
Makes
##Inspired by Simone Giertz
https://www.youtube.com/watch?v=pIUybAxuCMQ
The Lampshade and the pot are prepared to hold magnets (1cm diameter) to make the shade magnetically attach to the pot without having to remove the lightbulb.
The magnets are held in place by friction but glue was added anyways.
In addition to the 3D Printed Parts, I attached thin wooden braces and two wooden rings from an old basket.
The Lamp itself was inserted into the pot and was water-sealed using silicone paste.
The Inner pot slides over the cable and lamp into place.
https://www.youtube.com/watch?v=pIUybAxuCMQ
The Lampshade and the pot are prepared to hold magnets (1cm diameter) to make the shade magnetically attach to the pot without having to remove the lightbulb.
The magnets are held in place by friction but glue was added anyways.
In addition to the 3D Printed Parts, I attached thin wooden braces and two wooden rings from an old basket.
The Lamp itself was inserted into the pot and was water-sealed using silicone paste.
The Inner pot slides over the cable and lamp into place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
