Thingiverse
Planer/Jointer (TC-SP 204) parallel table fix.
door Phlexx
1
Downloads
1
Likes
0
Makes
Eccentric bushing to make outfeed table adjustable and parallel with infeed table.
You might need to sand down the seam if it sticks out too much.
Printed with 0.25mm hole compensation setting
Loosen the screw marked with 1 and 2. (both sides)
Remove the screw in box 1. (both sides)
Insert bushing on both sides, make sure its all the way in.
Insert eccentric bushing and screw it in.
Rotate the bushing to adjust the table.
Tighten everything once its adjusted.
You might need to sand down the seam if it sticks out too much.
Printed with 0.25mm hole compensation setting
Loosen the screw marked with 1 and 2. (both sides)
Remove the screw in box 1. (both sides)
Insert bushing on both sides, make sure its all the way in.
Insert eccentric bushing and screw it in.
Rotate the bushing to adjust the table.
Tighten everything once its adjusted.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
