Planetary Explorer Module Action Figure Seat Gamma

Updated seat to use latest pla snap connector e connector. Also added a top. The top has a slot where you can slide in a window film.

This is a seat / cockpit for your 3.75 inch / 1:18 scale action figures. Even action figures get tired of standing! It has holes and connectors that are intended to connect to either more of this same item or eventually others as well.

Seat prints OK with no supports. No special printer resolution required, although the buttons will look better at higher resolutions. Note the attachments in the middle for a rubber-band seat belt. This is to keep the pilot in the seat even while upside-down!

This is meant to be just a beginning, not an end! Some design principles I will try to follow:

- no glue required
- modules may be connected / disconnected by hand with no screwdriver or additional tools required
- allows for many different combinations to allow you to easily create your own unique constructions
- not too many parts per mo