Planetary Gear Menorah v2

This is version 2 of the planetary gear menorah I designed 4 years ago. I redesigned version 2 from the ground up. The printed parts are entirely snap together and it prints without support material (except for one part)!

Check out version 1 here: https://www.instructables.com/id/How-to-Make-a-Planetary-Gear-Menorah/

##Building Guide##
Print 2x `Crank-Base-Connector_2x.stl` and 8x `Planet-Gear_8x.stl`. Print one of all other parts. Consider printing a `Planet-Insert-Test.stl` before attempting to print the menorah to confirm your printer is capable of successfully printing the menorah.

In addition to the printed parts, you will also need:
- 27x - 6-32-5/16" Screw (McMaster: 91772A145)
- 9x - 3/8"-16 T-Nut (McMaster: 90611A450)
- 8x - Small, adhesive backed rubber feet (Amazon: https://www.amazon.com/dp/B073W1B3G1/)
Note: You do not have to get these specific pads, they're just the ones I used.

##User Guide##
Screw the candles into the T-nuts. You may need to