Planetary Gear Stand

You can use this as a fidget toy, or as a stand.

It doesn't matter what settings you use too much when printing except for the stabilizers, but here's what I did:

For everything I used PLA. For the Ring Gear, planetary gear, aligner, sun gear, and stand/holder I used three perimeters with a 15% infill. I used 0.1-0.2 layer height.
For the Sun Gear Handle, I used all of those settings, but also printed it on its side, so it only had supports where the stake would go in the sun gear, and so it would be stronger.

For the pins, I also used 0.1-0.2 layer height. I did this at 5% infill, and only one perimeter.

You will want to print:

• Three Planet Gears
• Three Stabilizers
• One Sun Gear
• One Sun Gear Handle
• One Aligner
• One Stand/Holder
• One Ring Gear

Assembly:
• You can place the aligner over all four gears, in their designated placement
• Now that these are all placed, you can put the stabilizers over the planet gears where the diameter is the smallest (You may need pliers to