Planetary Phone Stand

I was inspired by [this](https://www.myminifactory.com/object/3d-print-emma-phone-stand-gadget-46178) and assembled it, but it uses too much screw like about 20+ screws. I saw [this](https://www.thingiverse.com/thing:3529558) and I got idea on mashing both together to create a phone stand out of a planetary gear systems. In fact, I always wanted to make a rather unique, print-in-place and adjustable phone stand without too much complexity on assembling it after printing. Please continue reading on what you're going to deal with here =D

##Specification
- Offset types can go as much as 90' degree angle
- You can slide charging cable from the channel by the feet
- Clearances were set to 0.125mm or backlash of 0.25mm on gear generator.
- Face between gear's teeth measured around 0.13-0.17mm

##Print setting
- Design is optimised for 0.2mm layer height but you may get away with 0.3 or 0.15
- When doing a "test print.stl", enable "detect bridging parameter" (prusa slicer) to simul