Plankton - A1/Mini Extruder Cover + Visualizer

A Sheldon J. Plankton Extruder Cover And Visualizer For A1 Series Printers Simply use the painted profiles provided to print your very own Plankton Extruder cover! There are only 2 parts: The Cover: This clips on exactly like the stock cover. Clip the top in first and give a firm press somewhere near Planktons mouth to locate the bottom 2 clips. The cover was painstaking modelled to be as close to the original as possible and still be printable. The Eye: Pull off your stock visualizer and replace with the eye. It push fits onto the stock shaft with a firm press. It should be tight up to the plastic casing when fully seated. Separated into 2 plates requiring 4 colours per plate, this print is achievable on any Bambu Lab printer with only 1 AMS. Total print time is around 1hr30mins for a full colour Plankton. *Please ensure your bed is clean before printing. Good bed adhesion is crucial for a nice looking Plankton. If the first layer doesn't stick perfectly, then it will ruin the whole p