Plant protector, 25cm inner diameter

This model helps you protecting garden plants from animals, e.g. rabbits, turtles or chicken.
The rings are designed with a inner diameter of 250mm at 100% scaling. The protector can be assembled with chicken wire in any height.
Chicken wire is put in between holding parts, forming an upper and bottom ring.

Three variants can be built:
- *Full circle with spikes on the bottom*
- *Full circle with wall holders to fasten with zip ties or screws*
- *Semicircular with spikes on the bottom*

The parts can be printed on a 200x250mm plate.
I used PETG as material and fuzzy skin for the outer printing walls.

Two full rings are formed by 4 parts each (2 inner half rings and 2 outer half rings), so 8 parts in total. These are held together with M4 screws, washers and nuts. The height of each ring is 3cm.
The design allows to build the plant protector in one piece or to build it "around" existing plants, if needed.

**Full circle protector with spikes**
- 4 prints of "Plant protector 250mm inn