Thingiverse
Plant Stand
di Olenscho
2
Download
4
Likes
0
Makes
A modular plant stand with lights for each plant.
The diffuser is not needed, but can be printed in "transparent" PLA.
I drilled holes for each lamp, and ran cables through the rod down to the base, where I have an arduino controlling the lights. You could use bluetooth or WiFi, but I decided to use a rotary encoder, for which I have included a casing and a knob.
Measurements:
122mm pot diameter (requires some sort of lip or width larger than 122mm to not fall through.
28mm shaft diameter (mine is a curtain rod from IKEA).
The LED rings need to have an inner diameter of at least 50mm, and an outer maximum diameter of 66.5mm (Most 24 LED rings should work).
The diffuser is not needed, but can be printed in "transparent" PLA.
I drilled holes for each lamp, and ran cables through the rod down to the base, where I have an arduino controlling the lights. You could use bluetooth or WiFi, but I decided to use a rotary encoder, for which I have included a casing and a knob.
Measurements:
122mm pot diameter (requires some sort of lip or width larger than 122mm to not fall through.
28mm shaft diameter (mine is a curtain rod from IKEA).
The LED rings need to have an inner diameter of at least 50mm, and an outer maximum diameter of 66.5mm (Most 24 LED rings should work).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
