Plantation Window Shutter Magnet

Replacements of some magnet housings meant to hold plantation windows shut. The original housings are made from ABS. I replaced them with PCFR; but I'm sure ABS, PC, any engineering filament, PETG, or even PLA would work. I didn't use supports at all just let the filament bridge the ribs. The ribs are meant to prevent the same failure method I saw on the original housings. The slots are 0.150" width. the wood screws holding my brackets in were 1/8th" diameter. If you don't have the original magnets the second model in the distribution allows for using cheap 19mm amazon magnets. I used 4 magnets stacked together to get adequate pull even with some warped windows. If you want to use less you can just offset the thicker side of the cavity. I would leave the 0.05" side alone.