Thingiverse
Planter 14cm diameter
von DrVork
1
Downloads
0
Likes
0
Makes
It's the smaller one on the photo, I alse posted the big one.
Diameter 13cm height 10cm.
Printed in PLA with the following settings:
0.2mm layer height
No infill
No support
5 bottom layers
5 perimiters
0 top layers (very important)
This gave me a watertight pot.
Please post a make if you made one.
Diameter 13cm height 10cm.
Printed in PLA with the following settings:
0.2mm layer height
No infill
No support
5 bottom layers
5 perimiters
0 top layers (very important)
This gave me a watertight pot.
Please post a make if you made one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
