Thingiverse
Planter Base for Snack Cups
von hankr
1
Downloads
3
Likes
0
Makes
The Planter Base for Snack Cups design allows you to upcycle the single serving plastic cups that fruit snacks and apple sauce are packaged in as small planters instead of discarding them. The planter base should accommodate cups up to 42mm in diameter.
The chute on the side of the base allows you to easily bottom water the planter.
You will need to make holes in the bottom of the snack cups for drainage. I use an inexpensive soldering iron to make the holes, but a drill should work as well.
I have also included a design for a printable inner cup in case the fruit snack cups are unavailable to you.
I use this design along with my Plant Support Ring design (https://www.thingiverse.com/thing:6958757) to propagate succulents and it works very well!
Printing:
I printed this design on a Creality Ender-3 V3 KE using generic PLA filament and the default 0.20mm Standard settings in Creality Print 6.0. No supports are necessary.
The planter base is optimized to print with three wall layers us
The chute on the side of the base allows you to easily bottom water the planter.
You will need to make holes in the bottom of the snack cups for drainage. I use an inexpensive soldering iron to make the holes, but a drill should work as well.
I have also included a design for a printable inner cup in case the fruit snack cups are unavailable to you.
I use this design along with my Plant Support Ring design (https://www.thingiverse.com/thing:6958757) to propagate succulents and it works very well!
Printing:
I printed this design on a Creality Ender-3 V3 KE using generic PLA filament and the default 0.20mm Standard settings in Creality Print 6.0. No supports are necessary.
The planter base is optimized to print with three wall layers us
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
