Planter- (higher balcony)

Always felt like the balcony for this is too low, the water easily run over.
created this part which fits perfectly on top, just print it and then glue it on top of the existing balcony if you have already printed the original planter 2.

a tip is to use a bit of putty filler after you glued it on to even out the cracks then sand it down and repaint it again in any color you might have painted it with.

I also included the already merged stl file including the higher balcony as one single peace so that you do not have to glue it on top after wards if you want to print this whole thing from scratch :) note that the total size has also been increase for this version, as I felt the original was a bit too small for any plants I had, this fits the ender 3 pro build plate perfectly, maxed out. the single balcony file by itself is however still the same size as the original Planter 2.

https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the f