Plaster and Lathe Clamp

My first useful 3D Model I've made these small disks will help repair old plaster in Plaster and Lathe Homes. Prep by drilling holes through only the plaster along the crack at about 4 inch intervals on both sides of the crack (Use a masonry bit for best results)Mix School Glue and water in a spray bottle in a 50/50 solution and spray into each hole wiping any excess that drips out (This preps the lathe beneath)Inject Kwikrete into the holes using a caulking gun making sure to fill the hole all the way Finally using Drywall Screws with the plaster clamp attached drill into the crack making sure the screw goes through the Lathe using the clamp to pull the plaster back onto the Lathe. (Lathe if very old and brittle can crumble around clamp fill with Plaster if this happens) Leave to set for 24 hours and then unscrew clamps from the wall slowly (Clamps are reusable if undamaged) Thank you to my beautiful wife who had the original idea and happy home restoration!