Thingiverse
Plate leveling patterns for Replicator 2 & 2x
door jmcskixc
51
Downloads
34
Likes
0
Makes
Simple linear pattern for checking plate level-ness. Prints in about 1 minute. 2 files, each one sized for Replicator 2 and 2X build plates, respectively.
Inspect the printed lines for adhesion and width. Width variance should be a tell-tale for where the plate is low or high. Adjust leveling screws until the lines are all the same thickness and well adhered to the plate.
Comments welcome.
Inspect the printed lines for adhesion and width. Width variance should be a tell-tale for where the plate is low or high. Adjust leveling screws until the lines are all the same thickness and well adhered to the plate.
Comments welcome.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!