Plate Scraper & Wiper

EDU (every day use) plate scraper, plate wiper, and a holder for both. The scraper uses the blade and screw included with your bambulab printer. It makes removal of prints, supports and purge lines effortless. The wiper allows you to clean your build plate. I reccomend using a microfiber cloth (cutting it to approximately 4.5"X4" is best). It will work with a range of cloth types, including the ones you get with some electronics (i.e. mobile phones, tablets, etc..) or for eyglasses. Just place the cloth on the bottom of the wiper and hold it in place with the retainer. Apply some alcohol and get to cleaning. I reccomend 70% IPA, and a small spray bottle to apply it. I'd like to point out that in my experience when i've used a cloth only approach, if you contact the lead screws, your cloth gets grease on it and can potentially spread to the build plate, which isn't good. This wiper allows you to get to every corner without getting the wiping surface dirty with grease