Thingiverse
Plate Wall Mount
door Zaniix
14
Downloads
6
Likes
0
Makes
I wanted to make something to hold a plate on the wall. I have to admit that its a bit over-engineered. I could have made it thinner, but I wanted to make sure the plate would not fall.
Printed it from MakerGeeks Raptor PLA at 100% infill
It would probably have been fine at 30% -50% infill
Requires supports for the overhangs at the very top.
Printed it from MakerGeeks Raptor PLA at 100% infill
It would probably have been fine at 30% -50% infill
Requires supports for the overhangs at the very top.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
